×

You are using an outdated browser Internet Explorer. It does not support some functions of the site.

Recommend that you install one of the following browsers: Firefox, Opera or Chrome.

Contacts:

+7 961 270-60-01
ivdon3@bk.ru

Selection of the optimal structure and method of performing assembly operations

Abstract

Selection of the optimal structure and method of performing assembly operations

Abbjasov V.M., Bavykin O.B., Buhteeva I.V.

Incoming article date: 19.06.2015

The practice of using pneumovortical assembly methods has confirmed their high efficiency and reliability. But at using assembly equipment units, first of all orienting-assembly modules (OAM) there were some cases when the part fed to the plate performing rotating-swinging oscillations, didn't reach the seatings meant for it, and sometimes even left the plate. It was accounted for an unfavourable combination of a number of the module's constructive parameters, and also the parameters characterizing its working conditions. So it would be rather timely to analyze orienting-assembly modules with the purpose of revealing such meanings of their parameters, at which parts’ orientation and assembly is carried out with 100 percent reliability, and, if possible, at a minimal time. In other words, the parametric optimization of pneumovortical modules is necessary, and, first of all, of the orienting-assembly ones (OAM).

Keywords: pnevmovihrevoy method, vibration disk, the oscillation frequency, the assembly module